Tag Archives: wire

Altec 1592B repair, 1588B module, XLR pinout output etc

Recently i got a nice Altec 1592B mixer.

Each input requires a dedicated preamp/transformer module, for microphones there’s preamp, 1588B or preamp+12v phantom power, model 1588C.

I had to do a massive recapping job on the 1592B- the original caps values were all over the place-and i mean not only electrolytics-the only ones that were still measuring ok were the tropical fish and some of the lowest values disk caps- though most of them were good quality, Mallory or West Germany made, ROE (Roederstein). Replaced all with Elnas (they seem to be the standard nowadays).

Also, the resistor after power transformer 7818 (that feeds part of the tone section, so if you have an unit that powers up but does not produce a sound, check for +18v at pin 6 of the tone board, that is linked to the power board after (out) the aforementioned 7818) was burned-clear sign that some damage had taken place. The schematic calls for a 10 Ohms resistor-i decided to put a 100 ohms substitute, much better.

Sounding good, i decided to recap also the 1588B module i have here (more are on the way, and when factory new, they were fitted with 3 modules).

After using a small screwdriver to pry the enclosure open, i took a look at this interesting blog (check it) for the schematic-i also took the time to sub the carbon comp resistors with metal film and yes-noise went down.

For your reference, here’s the resistors network:

Since someone over at the Tape Operator forum has raised the warning that the power supply may have been ill designed, i am powering it using an external psu (using the battery option), 24v dc.

Terminal: from left, my battery (external psu) connections (- and +) and pinout to wire an XLR balanced jack to the output: hot, cold and ground… in the mess between high and low impedance i went with, 600 ohms, good for any mixer or recorder input. PLEASE note 2 and 3 terminals are bridged (connected) at the terminal post. The signal is nice and strong.

I will not mod this unit, i like it as it is. Nice and retro sounding.


Hohner Basset

When i bought it it looked like this

I opened it up to clean it and realised this wasnt its original colour.

It really was taupe gray before, but the years had the plastic chassis yellowing

I decided to restore it to its original colour (or as close as i could…)

After 5 months of great fun, I had to open it up because the output went silent.

Gutshots of the Hohner Basset!

Lets start with the DIN jack that connects it to the bass amp..


Circuit board and caps jungle:

Inside the white enclosure there’s a lamp and a ldr.. this assembly is the actual “percussion” section.

You press a note on the keyboard, the light goes off slowly (sustain) according to the knob position, when not in auto mode.

Video below..

Pcb: 3.1967!!

Ahem this means the caps have been doing their job for 50 long years! Only one of the capacitors has failed, please note- the blue valvo 100uF cap now measures 1uF!

Output DIN and 3 pronged jack, fuse

Video showing the lamp going off when a note is keyed.